RIBBED ROLLER ASSEMBLY | ||||||||||||||||
Designed with lightweight 1 1/8" Aluminum bar and pivot plate. | ||||||||||||||||
|
||||||||||||||||
BOLSTER SUPPORT SWIVEL BRACKETS | ||||||||||||||||
Bolster bracket and angle bracket assembly designed to support horizontal 2" x 6" bolster or bunk boards. Slotted for vertical adjustment to properly support stepped down boat hulls. Non-slip notches prevent movement of horizontal boards whole increasing load capacity. Made of 11 gauge zinc plated steel (7/16" diameter bolt and nut is not included). | ||||||||||||||||
|
|
||||||||||||
PANEL BRACKETS | ||||||||||||
Brackets are one piece, heavy duty zinc-plated 11 gauge steel, specifically designed to support keel rollers. Slot accept 7/16" or 1/2" diameter bolts and provide vertical roller adjustment. Non-slip notches hold bracket and roller securely in place. For 1/2" or 5/8" diameter roller shafts. |
||||||||||||
|
|
||||||||||||
PANEL BRACKET ASSEMBLY | ||||||||||||
|
||||||||||||
|
||||||||||||
|
||||||||||||
SPLIT PANEL BRACKETS | ||||||||||||
Manufactured in pairs (right and left) to accommodate any size roller length. Slot allows vertical adjustment for stabilizing boat on trailer. Made of 11 gauge steel and zinc-plated. Slots accept 7/16" or 1/2" diameter bolt. Use 1/2" or 5/8" diameter roller shaft. |
||||||||||||
|
|
||||||
BUNK BRACKETS | ||||||
Slotted to easily mount 2 x 4's for boat hull height adjustment. Slot accepts 7/16" diameter bolt. Made of 11 gauge steel and zinc-plated for long life. Available in two sizes. |
||||||
|
||||||
PONTOON BUNK BRACKETS |
||||||
|
Part No. | Description |
---|---|
11 gauge steel hot dipped galvanized. 8.38" wide bottom x 15.68" wide top x 4.70" tall |
|
||||||||||||
KEEL ROLLER BRACKETS | ||||||||||||
Adjustable offset brackets mount on tongue to hold roller for keel support. Made of heavy 3/16" x 1 1/2" bar stock. Offset is 1". Length is 11 1/2". Mount with 3/8" diameter bolts. Use 1/2" or 5/8" diameter shaft for roller. |
||||||||||||
|
||||||||||||
|
||||||||||||
PAL NUTS | ||||||||||||
Pal Nuts: Attach to end of shaft to retain roller within bracket. |
||||||||||||
|
||||||||||||
|
||||||||||||
ROLLER SHAFTS | ||||||||||||
|
||||||||||||
|
||||||||||||
|
There are no products to list in this category.